The chain bucket elevator manufacturer tells you that the bucket elevator uses a series of hoppers that are evenly fixed on the endless traction member, a continuous conveying machine that vertically lifts materials, and the bucket elevator uses a series of hoppers fixed to the traction chain or tape. The bulk material is transported upwards in a vertical or near-vertical direction. It is divided into three types: ring chain, plate chain and belt. The chain bucket elevator manufacturer tells you that the bucket elevator is a kind of conveying equipment for vertically lifting materials. It has the advantages of simple structure, low maintenance cost, high conveying efficiency, high lifting height, stable operation and wide application range. The driving power is small, and the inflow feeding, induction discharging, and large-capacity hopper are densely arranged. There is almost no material returning and digging when the material is lifted, so the ineffective power is small.

1. We must carry out no-load test operation, and do not install it immediately after full-load operation, which is prone to more serious accidents, such as material head breakage, bearing burnout, etc. Many people may feel less serious, but this is ours The situation seen by the after-sales personnel of the crane should be driven with no load. Therefore, all material in the hopper should be drained before each stop, and then stopped.
2. It is necessary to pay attention to the direction of operation. We have to make sure that the bucket elevator is running forward, i.e. from bottom to top. If the opposite happens, serious problems can arise. on the contrary. The chain bucket elevator manufacturer tells you that if the reverse is reversed, chain derailment may occur, and it is very troublesome to eliminate the derailment failure.
3. The point is to remind our dear users that when you use the bucket elevator to transport, you must work strictly according to the design capacity, and you must not dig our dig very deeply for the sake of instant speed, which will cause us serious problems. Overload or overload, if the overload is serious, too much carton feedback will cause the carton phenomenon, causing the motor to stop or the motor to burn, and the feeding is even. Sudden increases in feed volume are prohibited. The feed volume should not exceed the conveying capacity of the elevator. Otherwise, when the material at the bottom accumulates seriously, it is easy to cause a "stuffy car" accident.
4. Supplement lubricating oil in time. The chain bucket elevator manufacturer tells you that it is very important to lubricate a part of the elevator. For a machine with good lubrication performance, it is very important to achieve good operating results.
5. The chain and hopper should be replaced in time to avoid serious wear or damage. Then this point is also very correct and very important. The chain bucket elevator manufacturer tells you that because the chain and the hopper are consumables, because we can imagine that the hopper is in direct contact with the material, there will be wear and tear, and the chain will continue to drive the chain hopper. Running, well, it's also subjected to a lot of force, so it also causes a lot of wear and tear, so because of the wear and tear, we need to replace it in time.