The vertical bucket conveyor product is suitable for lifting from low to high. After the supply material is put into the hopper through the vibrating table, the machine automatically transports upwards one after another. The conveying speed can be changed according to the conveying volume, and the height can be selected as required. If the vertical bucket conveyor is unnecessary for a period of time and needs to be disassembled and stored, what should we pay attention to when disassembling it? The use of vertical bucket conveyors in the production process is not used every day, often after a period of use, it is necessary to change the position or move into the room. At this moment, it is necessary to disassemble the vertical bucket conveyor equipment.

How to carry out safe and orderly disassembly work, and how to ensure that "installation under" does not affect the normal operation of the equipment. When disassembling a shovel machine, the first thing to keep in mind is safety. Before dismantling the shovel vertical bucket conveyor, the person in charge needs to make a plan according to the equipment drawings, and write down the written regulations on the dismantling of the shovel vertical bucket conveyor, the rear equipment, the order and the new location. Operators need to increase bucket-style drive and employ inflow feed, induction discharge, and a dense arrangement of high-capacity hoppers. When the material is raised, there is no material return and material excavation, so the inactive power is small; this type of machine has lower requirements on the type and characteristics of the material, and can not only change the general powder and small granular materials, but also change the material's High wear resistance, good sealing performance, less environmental pollution; good operational reliability.
Advanced design principles and processing methods ensure the reliability of the whole machine. Improve the running smoothness of the machine and make it reach a higher height; long service life, the machine feed reaches the change, and the inflow type is adopted. There is no need to use bucket material for digging, and there is little pinching and collision between materials. The vertical bucket conveyor is maintained and managed by designated personnel, and the key of the power switch box is managed by designated personnel.
Vertical bucket conveyors need to have lift limiters and travel limiters. The stopper should automatically stop the pulley before raising it to 300 mm of the spacer drum or pulley. Bucket machines should have large load marks. The weight must not be overloaded when the load is raised or lowered. After power-on, check the safety devices such as lift limiter, travel limiter and interlock switch, and the operation is reliable and reliable. You can drive after the bell before hoisting the crane and landing. People are not allowed to move up and down. After operation, increase the machine hanging plate should be grounded, then block the power supply, and close the upper and lower guardrail doors. Always insist on changing the sanitary conditions of the machine.